From Fried to Fixed: Commercial Slicer Board Repair
Sep 25
1 min read
Don't throw out that expensive board just yet! 🔧
This control board came out of a commercial meat slicer. A component blew and burned right through the circuit traces, so the board was completely dead. Replacement boards for these slicers are really expensive.
Instead of buying a new one, I replaced the blown part and rebuilt the damaged traces with jumper wire. See that green light? The board is powered up and working again, for a lot less than the cost of a replacement.
If your commercial equipment, electronics or appliance has a fried board, reach out before you replace it. A lot of the time it can be repaired!
đź“ž Genuine Tech Geek, Electronics & Board Repair
Comments